V Drone Tech

This 433MHz 100mW Radio Telemetry Module V2 Kit is based on the 3DR Telemetry Kit and runs the same firmware on board, making it 100% compatible. This firmware used by 3D Robotics is completely open source. This is why it is available in its own version of Unmanned Tech.

The Unmanned Telemetry Kit is compatible with Ardupilot or Pixhawk-based systems and easily adds a bi-directional telemetry link between the drone and ground station. It comes with full support and warranty because it is a product that is confident in its functionality and reliability.

New and improved V2 of the Unmanned Telemetry Kit. Full features and specs are listed below, but the main feature is that both the air module and base module are now interchangeable, each fitted with a USB connector and a DF13 connector.

I also recommend buying a 6-pin to 6-pin cable as it’s easier and better than using the supplied cable when connecting to the Pixhawk.

1. Very small size & Lightweight (under 4 grams without antenna)
2. Transparent serial link
3. MAVLink protocol framing and status reporting
4. Frequency hopping spread spectrum (FHSS)
5. Adaptive time division multiplexing (TDM)
6. Support for LBT and AFA
7. Configurable duty cycle
8. Interchangeable air and ground modules
9. Micro-USB port
10. 6-position DF13 connector
11. 100 mW maximum output power (adjustable)
12. Based on HopeRF’s HM-TRP module
13. RP-SMA connector
14. 2-way full-duplex communication through adaptive TDM
15. UART interface
16. Transparent serial link
17. MAVLink protocol framing
18. Frequency Hopping Spread Spectrum (FHSS)
19. Configurable duty cycle
20. Error correction corrects up to 25% of bit errors
21. Configurable through Mission Planner and APM Planner
22. Built-in error correcting code (can correct up to 25% data bit errors)
23. The demonstrated range of several kilometers with a small Omni antenna
24. Can be used with a bi-directional amplifier for even more range
25. AT commands for radio configuration
26. RT commands for remote radio configuration
27. Adaptive flow control when used with APM
28. Based on the HopeRF HM-TRP radio module, featuring a SiLabs Si1000 RF microcontroller.